Customer Service
Site Map
Home
Search Site
Products and ServicesIndustry NewsYour IndustryInternational MarketsContact UsInside Coen

< Back

CFD & Scale Modeling
Liquid Fuel Atomizers
Low NOx Gas Conversions
NOx & PM Compliance
Oil Low NOx
Oil Low Particulate
R & D Studies

 

Click on image below to download a PDF of the brochure.
Performance & Environmental Services
Click here to order a  hard copy of the brochure.

Oil Low Particulate
CP-REACH For Oil-Fired Boilers
Reduced Emissions and Advanced Combustion Hardware
T-Fired and Wall-Fired Burners
  • Revitalize Existing Units
  • Fraction of the Cost of New Burners
  • Reduce Particulate
  • Tangential-Fired Boilers
  • Wall-Fired Boilers
Innovations in oil atomizer and flame stabilizer technology deliver substantial improvement without full burner replacement.
Proven in Over 90 Utility and Industrial Boilers Totaling Over 15,000 MW of Generating Capacity

Emissions Reductions

  • Particulate Matter Reduced by up to 70%
  • Reduce Opacity - at Full Load & During Fast-Ramp Transients

PM Reduction with CP-REACH
300 MW Tangential-Fired Boiler

PM Reduction with CP-REACH

Unit Performance

  • Reduce Unburned Carbon by 25-75%
  • Achieve up to 4:1 Burner Turndown
  • Improve Flame Shape
  • Improve Flame Stability & Unit Reliability

Economic Benefits

  • Low Capital Investment - 10% of the Cost of Complete Burner Replacement
  • Unit Efficiency Improvements up to 1%
  • Reduced Excess Air With Low Emissions
  • Burn Lower Cost Fuels With Low Emissions
  • Minimize Unit De-rating

The Critical Burner Components
Critical Burner Components

In the majority of retrofit applications, these components replace the existing burner flame stabilizers and atomizers, while other burner components are left intact. Retaining as much as possible of the original burner contributes to the cost advantages of REACH technology.

Typical Retrofit Project:

Site Inspection - In conjunction with plant personnel, pertinent design information is obtained and operating and performance improvement goals are defined.

Design and Fabrication - The flame stabilizer design is based on aerodynamic analysis of the burner. REACH oil atomizers are designed with consideration of the existing atomization method and the aerodynamics of the flame stabilizer. Oil atomizers are tested in a spray laboratory to confirm that design specifications are met.

Installation - Plant personnel usually install REACH components during a scheduled maintenance outage.

Start-up - Performance and Environmental Solutions provides on-site technical support, including optimization of the burner settings and evaluation of combustion system operation and boiler control.

Testing - Emissions testing to verify REACH performance or determine optimum combinations of operating parameters may be performed as part of a REACH retrofit.

REACH for Oil-Fired Boilers
 

For more information about these products and services, talk to your nearest Coen Sales Representative.

 

Back to top