CA Rule 4306 - Compliance Schedule

California Rule 4306 Compliance Schedule -Standard Option
Units to be in compliance at a stationary source		Emission Control Plan (ECP)	Authority to Construct (ATC)	Full Compliance
Group 1	At least 25% of the total number of units subject to this rule on June 1, 2005, excluding Group 4 = *if 1 unit or 1^st unit if up to 4 total, 1^st and 2^nd unit if 5-8 total, 1^st, 2^nd, and 3^rd units if > 8 total, etc.*	June 1, 2004	June 1, 2004	June 1, 2005
Group 2	At least 62.5% of the total number of units subject to this rule on June 1, 2006, excluding Group 4 = *2nd unit if 2 or 3 total, 2^nd and 3rd units if up to 4 total, 2^nd, 3rd and 4^th units if 5-6 total, etc.*	June 1, 2004	June 1, 2005	June 1, 2006
Group 3	100% of the total number of units subject to this rule on June 1, 2007 = *all units*	June 1, 2004	June 1, 2006	June 1, 2007
Group 4	A. Load-following units B. Units limited by Permit to Operate to an annual capacity factor of 10% or less as of June 1, 2005 C. Category I units at any stationary source that has no more than two units subject to this rule.	June 1, 2004	June 1, 2006	June 1, 2007

California Rule 4306 Compliance Schedule -Enhanced Option
Units to be in compliance at a stationary source		Emission Control Plan (ECP)	Authority to Construct (ATC)	Full Compliance
Group 1	At least 25% of the total number of units subject to this rule on June 1, 2005, excluding Group 4 = *if 1 unit or 1^st unit if up to 4 total, 1^st and 2^nd unit if 5-8 total, 1^st, 2^nd, and 3^rd units if > 8 total, etc.*	December 1, 2005	December 1, 2005	December 1, 2006
Group 2	At least 62.5% of the total number of units subject to this rule on June 1, 2006, excluding Group 4 = *2nd unit if 2 or 3 total, 2^nd and 3rd units if up to 4 total, 2^nd, 3rd and 4^th units if 5-6 total, etc.*	December 1, 2005	July 1, 2006	December 1, 2007
Group 3	100% of the total number of units subject to this rule on December 1, 2005 = *all units*	December 1, 2005	July 1, 2007	December 1, 2008
Group 4	A. Load-following units	December 1, 2005	July 1, 2007	December 1, 2008

Load-following Unit: For the purposes of this rule, a load-following unit is defined as a unit with normal operating load fluctuations and requirements which exceed the operational response range of an Ultra-Low NOx burner system(s) operating at 9 ppmv NOx. The operator shall designate load-following units on the Permit to Operate.

Emission Control Plan (ECP): The ECP shall identify all units that are subject to this rule and the steps to be taken to achieve compliance. The ECP shall contain the following minimum information:

Authority to Construct (ATC): An ATC Application must be submitted by the owner/operator for each unit subject to this rule.

Full Compliance: Owner must demonstrate that each unit is in compliance with this rule.